Dakosaurus maximus : The Biter Lizard - UNPAINTED - Miniature Museum

**This listing is for one UNPAINTED resin print**

Dakosaurus maximus : The Biter Lizard - "Unlike modern crocodiles, Dakosaurus had a short, deep skull with serrated, blade-like teeth, earning it the nickname "the Jurassic killer whale."
These adaptations suggest it was a formidable predator, likely preying on large marine animals, including fish and other marine reptiles."

This print will be measured by length, the entire length of the print. If there is a certain size you need please just let me know.
Any print over 60mm may be printed hollow, which will have a small drain hole that I will replace and repair (but it will be there).
There will be a small hole and a rod to hold it to the base, these are all separate items, but are all included with the purchase.
25mm = One inch

The above pictures are from Miniature Museum inventory.

PLEASE READ ALL THE DESCRIPTION BEFORE YOU PURCHASE, ask any question you may have.

If the file has a base and/or multiple pieces (wings, arms, heads, etc.) I will send it UNGLUED unless otherwise stated in the comments. If the item has a very delicate part, supports may be left attached for stability during shipping.

PRIMED - If you need it primed I will have a separate listing to get primer added to your resin print. This is NOT painting the print I will just be airbrushing on primer (a solid colored undercoat) to make it easier for you to get it painted. I can't guarantee the resin will accept paint if not primed.

I start printing at the time of the order, and anyone who knows printing can tell you it can be a slow and tedious process (and prints can fail from time to time) so please allow 1-3 days to get it ready to ship out. 3D printing is not perfect and small imperfections or possible printing artifacts can occur. I do my best to fix anything I find. I would never send a print out that I wouldn't proudly display in my house.

I mainly use a light or dark grey resin, depending on which printer I use. All are printed on a 12k resolution printer. My steps are to print, clean, remove supports, clean again, uv cure for a durable print, check again for any possible flaws.

Open Range Miniatures is a licensed merchant to sell any physical print from Miniature Museum:

https://www.myminifactory.com/users/MuseumMiniatures?show=store

If you see something there you like, send me a message and I will get a price for you.

If you have ANY problem with your order PLEASE contact me to make it right, before you leave any review. I take customer satisfaction very seriously!