Fish Creature - UNPAINTED Fan Art - Siryll Art

**This listing is for one UNPAINTED Fan Art resin print.*
I use grey resin.

The above pictures are from Siryll Art inventory.

Fish Creature - " In the deep and dark abyss of the sea, a fearsome being takes shape in this breathtaking diorama: an extremely monstrous fish, depicted with vivid and terrifying details. Its round and vacant eyes seem to peer into the soul, devoid of any trace of humanity, while the mouth full of sharp teeth is ready to devour anything that dares to approach."

This print will be measured in length. The entire length of the print (fish thing), no matter which print you choose. If you need a certain size, please just ask.
Any print over 60mm may be printed hollow, which will have a small drain hole that I will replace and repair, but it will be there.
25mm = One inch

PLEASE READ ALL THE DESCRIPTION BEFORE YOU PURCHASE, ask any question you may have.

If the file has a base and/or multiple pieces (wings, arms, heads, etc.) I will send it UNGLUED unless otherwise stated in the comments. If the item has a very delicate part, supports may be left attached for stability during shipping.

PRIMED - If you need it primed I will have a separate listing to get primer added to your resin print. This is NOT painting the print I will just be airbrushing on primer (a solid colored undercoat) to make it easier for you to get it painted. I can't guarantee the resin will accept paint if not primed.

I start printing at the time of the order, and anyone who knows printing can tell you it can be a slow and tedious process (and prints can fail from time to time) so please allow 1-3 days to get it ready to ship out. 3D printing is not perfect and small imperfections or possible printing artifacts can occur. I do my best to fix anything I find. I would never send a print out that I wouldn't proudly display in my house.

I mainly use a light or dark grey resin, depending on which printer I use. All are printed on a 12k resolution printer. My steps are to print, clean, remove supports, clean again, uv cure for a durable print, check again for any possible flaws.

Open Range Miniatures is a licensed merchant to sell physical prints from Siryll Art Miniatures: https://www.myminifactory.com/users/SiryllArt

If you have ANY problem with your order PLEASE contact me to make it right, before you leave any review. I take customer satisfaction very seriously!