Beelzebufo ampinga : The Devil Toad - UNPAINTED - Miniature Museum

**This listing is for one UNPAINTED resin print.**

Beelzebufo ampinga : The Devil Toad - "Beelzebufo most likely was a predator whose expansive mouth allowed it to eat relatively large prey, perhaps even juvenile dinosaurs. Bite force measurements from a growth series of Cranwell's horned frog , suggest that the bite force of a large Beelzebufo—skull width 15.4 cm (6.1 in)—may have been between 500 and 2,200 newtons (110 and 490 lb)."

This print will be measured by the base, so if you order 40mm the base will measure about 1.5 inches in length and the print scaled to match.
Any print over 60mm may be printed hollow.
25mm = One Inch
If you need a certain size please just ask me.

The above pictures are from Miniature Museum inventory.

PLEASE READ ALL THE DESCRIPTION BEFORE YOU PURCHASE, ask any question you may have.

If the file has a base and/or multiple pieces (wings, arms, heads, etc.) I will send it UNGLUED unless otherwise stated in the comments. If the item has a very delicate part, supports may be left attached for stability during shipping.

PRIMED - If you need it primed I will have a separate listing to get primer added to your resin print. This is NOT painting the print I will just be airbrushing on primer (a solid colored undercoat) to make it easier for you to get it painted. I can't guarantee the resin will accept paint if not primed.

I start printing at the time of the order, and anyone who knows printing can tell you it can be a slow and tedious process (and prints can fail from time to time) so please allow 1-3 days to get it ready to ship out. 3D printing is not perfect and small imperfections or possible printing artifacts can occur. I do my best to fix anything I find. I would never send a print out that I wouldn't proudly display in my house.

I mainly use a light or dark grey resin, depending on which printer I use. All are printed on a 12k resolution printer. My steps are to print, clean, remove supports, clean again, uv cure for a durable print, check again for any possible flaws.

Open Range Miniatures is a licensed merchant to sell any physical print from Miniature Museum:

https://www.myminifactory.com/users/MuseumMiniatures?show=store

If you see something there you like, send me a message and I will get a price for you.

If you have ANY problem with your order PLEASE contact me to make it right, before you leave any review. I take customer satisfaction very seriously!