Utahraptor Feathered - Primitive War - UNPAINTED - Clynche Art

**This listing is for one UNPAINTED resin print.**

Utahraptor Feathered from the novels Primitive War by Ethan Pettus - "Weighing nearly a full ton, Utahraptor was the largest, most dangerous raptor that ever lived, making close relatives like Deinonychus and Velociraptor seem positively shrimpy by comparison."

This print will be measured by length, no matter which print you order I will measure it from nose to tail tip (entire length of the raptor).
Middle Raptor comes with the knife in the eye or not, as in the novels.
Any print over 60mm may be printed hollow, which will have a small drain hole (I will replace and repair said hole, but it will be there).
I do not know or following table gaming measurements, if you need a certain size please let me know.
25mm = One inch

The above pictures are from Clynche Art's inventory.

PLEASE READ ALL THE DESCRIPTION BEFORE YOU PURCHASE, ask any question you may have.

If the file has a base and/or multiple pieces (wings, arms, heads, etc.) I will send it UNGLUED unless otherwise stated in the comments. If the item has a very delicate part, supports may be left attached for stability during shipping.

PRIMED - If you need it primed I will have a separate listing to get primer added to your resin print. This is NOT painting the print I will just be airbrushing on primer (a solid colored undercoat) to make it easier for you to get it painted. I can't guarantee the resin will accept paint if not primed.

I start printing at the time of the order, and anyone who knows printing can tell you it can be a slow and tedious process (and prints can fail from time to time) so please allow 1-3 days to get it ready to ship out. 3D printing is not perfect and small imperfections or possible printing artifacts can occur. I do my best to fix anything I find. I would never send a print out that I wouldn't proudly display in my house.

I mainly use a light or dark grey resin, depending on which printer I use. All are printed on a 12k resolution printer. My steps are to print, clean, remove supports, clean again, uv cure for a durable print, check again for any possible flaws.

Open Range Miniatures is a licensed merchant to sell any physical print from Clynche Art:

https://www.myminifactory.com/users/clynche?show=store

If you see something there you like, send me a message and I will get a price for you.

If you have ANY problem with your order PLEASE contact me to make it right, before you leave any review. I take customer satisfaction very seriously!