Polachantus rear up - Dino and Dog Miniatures

**This listing is for one UNPAINTED resin print.**

Polachantus rear up - " The spikes would've made it difficult to get close without a carnivore impaling its snout,‭ ‬and the sacral armour prevented a bite to the sacrum that could have paralysed Polacanthus.‭ ‬If the tail was also a defensive weapon,‭ ‬the sacral armour would have helped to prevent a predator from disabling its defence."

This print will be measured by the base, the longest side of the base will be the size you order. This print will be bigger than the size you order, because of this measurement way.
25mm = One inch

The above pictures are from Dino and Dog Miniatures inventory.

PLEASE READ ALL THE DESCRIPTION BEFORE YOU PURCHASE, ask any question you may have.

I offer all my prints in many different sizes so you can choose to have them for table top playing or just a fun project to paint and display (please refer to the sizing chart in my photos, if you are unsure what size you want).

If the file has a base and/or multiple pieces (wings, arms, heads, etc.) I will send it UNGLUED unless otherwise stated in the comments. If the item has a very delicate part, supports may be left attached for stability during shipping.

PRIMED - If you need it primed I will have a separate listing to get primer added to your resin print. This is NOT painting the print I will just be airbrushing on primer (a solid colored undercoat) to make it easier for you to get it painted. I can't guarantee the resin will accept paint if not primed.

I start printing at the time of the order, and anyone who knows printing can tell you it can be a slow and tedious process (and prints can fail from time to time) so please allow 1-3 days to get it ready to ship out. 3D printing is not perfect and small imperfections or possible printing artifacts can occur. I do my best to fix anything I find. I would never send a print out that I wouldn't proudly display in my house.

I mainly use a light or dark grey resin, depending on which printer I use. All are printed on a 8k resolution printer. My steps are to print, clean, remove supports, clean again, uv cure for a durable print, check again for any possible flaws.

Shrunk It is a licensed merchant to sell any physical print from Dino and Dog Miniatures:
https://www.myminifactory.com/users/Dino%20and%20Dog

If you see something there you like, send me a message and I will get a price for you.

If you have ANY problem with your order PLEASE contact me to make it right, before you leave any review. I take customer satisfaction very seriously!